Lightweight concrete based on porous aggregate from autoclaved aerated concrete
DOI:
https://doi.org/10.56143/3030-3893-2026-1-144-148Keywords:
autoclaved aerated concrete, AAC waste, porous aggregate, lightweight concrete, replacement level, internal curing, sulfates, ettringite, thermal conductivity, construction waste recyclingAbstract
The paper summarizes and critically reviews published experimental data on lightweight concrete with porous aggregate obtained by crushing autoclaved aerated concrete (AAC) waste. The relevance of the problem for Uzbekistan is shown, where 11 AAC plants operate and factory rejects are used only as unfractionated backfill. The influence of the aggregate grading and of the level of replacement of natural aggregate on the density, strength and thermal conductivity of concrete is considered. Three replacement ranges are distinguished: up to 10–15 % – without loss of strength, 15–30 % – optimal, and above 30 % – with a sharp drop in strength. It is established that with special mix design it is possible to obtain structural and heat-insulating concrete with a density of 850–1450 kg/m³ and strength of 4–16 MPa. The internal curing effect, the influence of sulfates and delayed ettringite formation on durability, and the role of chemical admixtures are analyzed. The conditions ensuring the quality of such concrete are formulated and rational fields of its application are identified.
References
[1] Steins J., Volk R., Schultmann F. Modelling and predicting the generation of post-demolition autoclaved aerated concrete (AAC) volumes in Germany until 2050. Resources, Conservation and Recycling. 2021;171:105504.
[2] Steins J.J., Volk R., Stallkamp C., Schultmann F. Designing a new recycling network for post-demolition autoclaved aerated concrete (AAC) in Europe. IOP Conference Series: Earth and Environmental Science. 2023;1196:012058.
[3] Stier C., Forberger J. Ergebnisse einer Befragung zum Umgang mit Porenbetonabfällen aus dem Abbruch von Gebäuden. Chemie Ingenieur Technik. 2016;88(4):506–513.
[4] Prajapati A., Kumar Sharma R., Lakhani R., Mishra R., Khan S. Utilization of solid waste in the production of autoclaved aerated concrete and their effects on its physio-mechanical and microstructural properties. International Journal of Concrete Structures and Materials. 2023;17:3.
[5] Runci A., Nielsen P., Peys A., Horckmans L., Quaghebeur M. Assessment of semi-dry carbonation on autoclaved aerated concrete and its pozzolanic potential in composite cement. Construction and Building Materials. 2025;505:144671.
[6] Bergmans J., Nielsen P., Snellings R., Broos K. Recycling of autoclaved aerated concrete in floor screeds: sulfate leaching reduction by ettringite formation. Construction and Building Materials. 2016;111:9–14. https://doi.org/10.1016/j.conbuildmat.2016.02.075
[7] Steins J.J., Volk R., Beuchle G., et al. Economic assessment of post-demolition autoclaved aerated concrete (AAC) recycling and subsequent belite cement clinker production. Circular Economy and Sustainability. 2026;6:88.
[8] Directive 2008/98/EC of the European Parliament and of the Council of 19 November 2008 on waste and repealing certain Directives. Official Journal of the European Union. 2008;L312:3–30. Article 11(2)(b). https://eur-lex.europa.eu/legal-content/EN/TXT/?uri=CELEX:32008L0098
[9] The total capacity of aerated concrete enterprises in Uzbekistan reaches 2.95 million cubic meters. UzDaily.uz. 13.08.2025. Available from: https://www.uzdaily.uz/ru/sovokupnaia-moshchnost-gazobetonnykh-predpriiatii-uzbekistana-dostigaet-295-mln-kubometrov/ (accessed 14.09.2026). (In Russian)
[10] Leontev S.V., Kharitonov V.A. Development of structural-heat-insulating lightweight concrete composition using production of aerated concrete waste as a porous aggregate. Journal of Physics: Conference Series. 2021;2124:012009.
[11] Aerated concrete crumb (loose-fill insulation). Arton. Available from: https://arton.uz/categories/gazobetonnaya-kroshka (accessed 14.09.2026). (In Russian)
[12] TU 2661-003-82651425-2019. Crumb of crushed cellular aerated concrete. Saratov; 2019. 4 p. (In Russian)
[13] Hlawatsch F., Aycil H., Kropp J. Autoclaved aerated concrete (AAC) rubble for new recycling building products. Mauerwerk. 2019;23:364–377.
[14] Volk R., Steins J., Kreft O., Schultmann F. Life cycle assessment of post-demolition autoclaved aerated concrete (AAC) recycling options. Resources, Conservation and Recycling. 2023;188:106716.
[15] Mukhamedbaev Ag.A. Light porous aggregate on the basis of autoclave aerated concrete. The Scientific-Practical Journal of Architecture, Construction & Design. 2025;(1):199–205.
[16] Mukhamedbaev Ag.A. Grid square diagram analysis of the physical parameters of autoclaved porous aggregate. Journal of Scientific Works of Azerbaijan University of Architecture and Construction. 2026;(1):5–13.
[17] Liu Q., Xiao J., Singh A. Plastic shrinkage and cracking behavior of mortar containing recycled sand from aerated blocks and clay bricks. Sustainability. 2021;13(3):1096.
[18] Topçu İ.B., Sarıdemir M. Prediction of properties of waste AAC aggregate concrete using artificial neural network. Computational Materials Science. 2007;41:117–125.
[19] Mohd Affandy N.E., A. Majid M. The study of crushed autoclaved aerated concrete as sand replacement in concrete. Recent Trends in Civil Engineering and Built Environment. 2023;4(3):601–610. https://doi.org/10.30880/rtcebe.2023.04.03.064
[20] Murthi P., Veda Sri N., Mudassir Baig M., Abdul Sajid M., Kaveri S. Development of green concrete using effective utilization of autoclaved aerated concrete brick trash as lightweight aggregate. Materials Today: Proceedings. 2022;68(5):1599–1608. https://doi.org/10.1016/j.matpr.2022.07.316
[21] Roy P., Kotal A., Dutta S. Mechanical behaviour of light weight concrete with autoclaved aerated concrete aggregates. Lecture Notes in Civil Engineering. 2026;631:255–264. https://doi.org/10.1007/978-981-96-5898-5_24
[22] Suwan T., Wattanachai P. Properties and internal curing of concrete containing recycled autoclaved aerated lightweight concrete as aggregate. Advances in Materials Science and Engineering. 2017;2017:Article ID 2394641, 11 p. https://doi.org/10.1155/2017/2394641
[23] Sinica M., Sezemanas G., Mikulskis D., et al. Investigation of the composite material with inclusions of autoclaved aerated concrete chips. Materials Science (Medžiagotyra). 2009;15(4):356–362. https://doi.org/10.5755/j02.ms.26176
[24] Fenyvesi O., Jankus B. Opportunities in recycling AAC waste as aggregate for lightweight concrete. Építőanyag – Journal of Silicate Based and Composite Materials. 2015;67(2):66–70. https://doi.org/10.14382/epitoanyag-jsbcm.2015.11
[25] Bayraktar O.Y., Sarıgül E., Yüksel M., Jamal A.S., Kara H.O., Ayyıldız M.A., et al. Recycling aerated concrete waste as aggregate to produce eco-friendly foamed mortar (EFM). Structural Concrete. 2025;26(3):2650–2665. https://doi.org/10.1002/suco.202401353
[26] Poongodi K., Murthi P. Effects of using autoclaved aerated concrete block debris as lightweight aggregate on internal curing of concrete. Materials Today: Proceedings. 2023; advance online publication. https://doi.org/10.1016/j.matpr.2023.03.180
[27] Lam N.N. Recycling of AAC waste in the manufacture of autoclaved aerated concrete in Vietnam. International Journal of GEOMATE. 2021;20(78):128–134.
[28] Thai H.N., Kawamoto K., Nguyen H.G., Sakaki T., Komatsu T., Moldrup P. Measurements and modeling of thermal conductivity of recycled aggregates from concrete, clay brick, and their mixtures with autoclaved aerated concrete grains. Sustainability. 2022;14(4):2417.
[29] Kreft O. Autoclaved aerated concrete with sulphate content: an environmentally friendly, durable and recyclable building material. Mauerwerk. 2017;21:287–296.